Nissan Rogue Won’t Start – Brake is Locked!

Did you just try to turn on the car, but the brake pedal is stiff? Have you tried everything and still cannot get it to work?

This can happen to most brands, it’s not only a Nissan thing. Actually, it is quite common in most cars. However, the solution changes depending on the brand.

In this article, we will cover what causes a brake lock on Nissan Rogue. We will also provide you with solutions for each case.

Nissan Rogue: The Brake is Locked

So here is what you’re experiencing:

You got in the car and wanted to start it. You put your leg onto the pedal, but it’s stiff. No matter how much or how long you press it, it won’t work.

Now, that is a problem. If you can’t start your car, you’re stuck, and it’s preventing you from reaching your destination. So whether it’s for work, school, or a trip, it’s a bummer.

First things first, you need to find out what causes it in order to find a solution.

So let’s dive into it! 

What are the Possible Causes?

There can be a lot of reasons why your car won’t start. Here are some of them. 

Faulty Starter Motor And Battery Terminal

If you removed the starter wire from the battery, your brakes could become stiff. Also, when turning the key, a sequence of loud clicking noises could state a dead starter motor.

Hold the key in the start position to see a significant voltage decrease. If this happens, the starter motor’s electrical circuit is likely faulty.

You must check these things during the circuit inspection:

1. The battery
2. Fuses
3. Wires
4. Relay
5. Ignition switch

Corrosion in the battery terminals can cause stiff brakes as well. Also, connectors hidden behind the terminals may obstruct the connection.

Exhausted Brake Vacuum

Power brakes are now standard on every vehicle. The engine vacuum plays a significant role in the power assist. 

There is a little bit of vacuum in the car’s system stored when the engine is off. When the car’s engine is off, pressing the brake pedals will wear out the reserve vacuum.

The pedal for braking will become stiff as a result of this. But, again, it’s because there’s no power aid available.

Once you start the engine, the brakes will restore to their original state.

Ignition Switch Damage

If your vehicle is older, there’s a good chance the car’s ignition is failing.

It takes a bit of work to start a vehicle with a defective ignition switch 8 out of 10 times. Sometimes, the car might actually die just a few seconds later.

Ignition switches give the electricity that causes the detonator to snap. This produces spark ignites by combining air and fuel.

Common symptoms of a malfunctioning ignition switch:

• Slow engine start-up
• Dashboard indicators that blink

How Can You Fix the Problem?

Perform a fast diagnosis before attempting a quick repair.

First, start the engine and see if the brakes remain firm or on. Next, examine the brakes and check if the pedal for braking is still rigid.

To begin, look at the electrical switch. Next, look for the stoplight after pressing the brake pedal.

If the stoplight comes on, the electrical control is working correctly. However, if it does not turn on, you should investigate more.

Electrical switches are inexpensive and easily changed. If your electrical switch becomes damaged, it’s best to replace it. You can try out good quality low-cost electrical switches from a mechanic shop.

If the combustion light isn’t the issue, inspect the electrodes for corrosion.

If you have an automatic vehicle, try switching the car’s mode into park mode.

Replace the hydraulic pump if you have a vacuum leakage problem. After replacing the vacuum, leave it for about ten to fifteen minutes.

Inspect the battery. If it dies, you’ll need to replace it.

Overnight, the vacuum might seep down, resulting in rigid pedals. It does not, though, involve any significant automotive parts destruction.

Stomping on the pedal very hard will assist the pedal if this occurs. That’s all there is to it when starting the car.

Conclusion

The above covers all the most common Nissan Rogue locked brake issues.

However, if none of the above solved the issue or if you don’t feel comfortable enough to do it yourself, remember to contact a professional.

Most of the above solutions are inexpensive and will get you sorted in no time!